lead temperature
各位DX,在電源IC中有幾項溫度參數,如最大結溫,最大存儲溫度,還有一個lead temperature,如lead temperature 1.6mm from case for 10 seconds is 300度,不知在這里L(fēng)EAD TEMPERATURE怎樣譯才好?請DX賜教!
全部回復(7)
正序查看
倒序查看
@青春之歌
leadtemperature:引腳焊錫溫度,,,也就是IC耐焊性,,,一般IC可以在300度下耐焊性是10S以下,,,在DATASHEET里肯定有此溫度曲線的,在260度可焊性是3~5秒,,,
when the FB voltage is between 1.4 V and 0.5 V, the controller is commanding an excess of energy to be transferred to the load which in turn, drives the error higher and FB lower. When FB reaches 0.5 V, OUT pulses are terminated and do not resume until FB reaches 0.7 V. In this mode, the converter operates in hysteretic control with the OUT pulse terminated at a fixed CS voltage level of 0.4 V.
大XIA,在這句話中,drives the error higher and FB lower這段和the converter operates in hysteretic control with the OUT pulse terminated at a fixed CS voltage level of 0.4 V. 這句不知怎么譯為妙,請賜教!
大XIA,在這句話中,drives the error higher and FB lower這段和the converter operates in hysteretic control with the OUT pulse terminated at a fixed CS voltage level of 0.4 V. 這句不知怎么譯為妙,請賜教!
0
回復
@julia1688
whentheFBvoltageisbetween1.4Vand0.5V,thecontrolleriscommandinganexcessofenergytobetransferredtotheloadwhichinturn,drivestheerrorhigherandFBlower.WhenFBreaches0.5V,OUTpulsesareterminatedanddonotresumeuntilFBreaches0.7V.Inthismode,theconverteroperatesinhystereticcontrolwiththeOUTpulseterminatedatafixedCSvoltagelevelof0.4V.大XIA,在這句話中,drivestheerrorhigherandFBlower這段和theconverteroperatesinhystereticcontrolwiththeOUTpulseterminatedatafixedCSvoltagelevelof0.4V.這句不知怎么譯為妙,請賜教!
sss
0
回復
